Why inverters and UPS fail

- Advertisement -

All electrical and electronic equipment users in countries like India encoun­ter unusual difficulties in trying to cope with AC power problems. Among these problems are frequent blackouts due to in­adequate generation capacity and wide AC mains voltage variation due to inadequate distribution infrastructure. Also, poor quality of power results in distortion, spike/noise, frequency, sags/surges and dropouts, espe­cially when diesel generators are used to supplement utility power.

By Venkat Rajaraman (The author is CEO, Su-Kam.)

Friday, October 16, 2009: Due to these common power quality problems, creating a reliable inverter and UPS system poses a special challenge to manufacturers. If inverters and UPS systems are not specifically designed to address the power conditions mentioned above, then they may meet with a high failure rate.

- Advertisement -

Power quality varies significantly from one area to another and is typically worse in rural India than in urban India. Power disturbances are caused by the generation, distribution and use of power and lightning, and occur when a power station breaks down or if power switching takes place on the dis­tribution lines, transformers or high voltage lines. Lightning, too, generates vast amounts of excess energy, which manifests as a power line disturbance. A power disturbance can be defined as unwanted excess energy that is presented to the load.

Causes of power disturbances

  • Power disturbance originates both out­side and inside customer facilities
  • Load switching causes surges due to col­lapsing fields
  • Over loaded power distribution systems can cause significant voltage variations between peak and off-peak hours
  • Large diesel generators and variable speed drives can cause huge surge volt­ages inside buildings
  • Significant momentary load changes, such as heavy inrush currents, can cause severe voltage variations
  • Blackouts can cause severe voltage surges both on loss and return of power
  • Circuit breaker tripping and fuse blowing can cause severe surge voltages

Impact of power disturbances

Sags, under voltages, surges and over volt­ages can cause component overheating or destruction, or can trigger other electronic components such as SCRs. Component over­heating reduces the life and deteriorates the real reliability of the product as opposed to the estimated reliability, based on steady state conditions. False triggering of other compo­nents can lead to nuisance alarm tripping, or worse, can cause overheating or destruction of other electronic components.

Why semiconductors fail

Most semiconductor devices are intolerant to surge voltages in excess of their voltage ratings. Even a rapid surge of a few micro­seconds can cause a semiconductor to fail catastrophically, or may degrade it so as to shorten its useful life. Damage occurs when a high reverse voltage is applied to a non-conducting P N junction. The junction may avalanche at a small point due to the non-uniformity of the electric field. In this case, thermal runaway can occur because of localised heat build up and cause a melt-through, which will destroy the junction.

Problems with current solutions

  • Typical EMI filters used in most systems are not well damped, which produces dramatic effects in case of voltage dis­turbances, resulting in oscillations inside the EMI filter under transitional condi­tions. Severe voltage surges may result from fly-back from saturated inductors, looking for a path to release energy
  • Boost converters can be destroyed by surges, causing increased energy storage in input filters. The output capacitor (c) is charged to an unsafe level depending on capacitance value and load levels for the DC/DC converter connected to the output of the boost

Installation and wiring practices

  • Installation and wiring practices are very important to ensure a reliable installa­tion. Some common problems are:
  • Inadequate wire size or type
  • Long overloaded wire runs
  • Too many loads on a branch circuit
  • Poor connections
  • Ground currents due to incorrect wiring
  • Systems that do not have a clear path to ground for fault currents have to rely on ground fault detection that sometimes malfunction
  • Mixing electrical equipment that is de­signed for different standards
  • Overloaded utility transformers
  • Incorrectly applied surge protection devices

Limitations of inverter and UPS equipment

Due to the frequency of power disturbances, the power electronic circuitry in the in­verter/UPS must work under greater stress. This especially holds true for inverters and line interactive UPS, which must make the transfer to battery backup every time there is a power disturbance. Also, power transis­tors and transformers must operate at higher currents and voltage levels during brownout and over voltage conditions, which result in a shorter-than-normal operating lifetime for the inverter or UPS system. Batteries cannot be charged fully when power disturbances occur so frequently. Consequently, inverters/UPS cannot render the rated backup time during each power disturbance.

Standby power generators such as DG sets can cause special problems when they are used to power inverters/UPS systems. They are known to release wide frequency/ voltage fluctuations, surges/spikes and high­ly distorted (often non sinusoidal) outputs, which can cause continuous mains/inverter transfer operations, shutdowns and even catastrophic failure.

If the ambient temperature is outside of the optimum 10-25°C range, standard flooded lead acid batteries cannot be used. Standard flooded batteries are rated to work only when the temperature is above 0°C and sudden battery failure can occur when the operating temperature goes above 40°C. Even at 30°C, expected battery lifetime is reduced by 50 per cent, compared to the expected battery lifetime at 20°C. Also, the industry is driven by low cost and users don’t care much about power quality. Most inverters/UPS systems do not possess quality battery chargers. If they do, the chargers are not designed for long-term backup. Most inverters and UPS do not provide real power conditioning (there are exceptions). Some UPS equipment are poorly protected against surge voltages.

Providing the ideal solution to power problems in developing countries requires an intelligent usage of technology, coupled with an intimate familiarity with the nature of the problems.

Electronics Bazaar, South Asia’s No.1 Electronics B2B magazine


- Advertisement -

Most Popular Articles

Applied Materials, Absolics, ASU Win $100M Each For Packaging Innovation

0
To advance semiconductor packaging, boosting AI and tech innovation, the U.S. government has awarded up to $100 million each to Applied Materials, Absolics, and...

Vingroup Unveils VinRobotics For AI And Automation Advances

0
VinRobotics, boasting a charter capital of VND 1,000 billion, will concentrate on crafting intelligent robotic products and solutions aimed at boosting production efficiency. These...

India’s Mobile Export Boom Pushes For Airport Infrastructure Overhaul

0
New airports to keep up with India's mobile export surge? To meet $180 billion target by 2030, manufacturers are urging upgraded and expanded cargo...

Ather Energy Introduces ‘Eight70 Warranty’ For EV Scooter Batteries

0
The Eight70 Warranty provides protection for either eight years or 80,000 kilometres, depending on which limit is reached first. Electric two-wheeler manufacturer Ather Energy introduced...

India To Offer $5B Incentives For Electronics Manufacturing

0
Eyeing to reduce Chinese imports and powering its $500 billion industry goal, India plans to offer up to $5 billion in incentives to boost...

“We Bring Intelligence Early On Into The Design Cycle” – Michel Van Cotthem VP...

0
With a solution embedding intelligence early in the design-to-source lifecycle, Supplyframe aims to leverage India’s electronics manufacturing boom. At IEW 2024, Michel Van Cotthem...
Vijai Karthick Selvam, Director of Teqtis

“We Do Everything From The Initial Concept To The Final Box Build” – Vijai...

0
Why are testing and R&D essential to combat printed circuit board manufacturing challenges? Speaking to EFY's Nitisha Dubey, Vijai Karthick Selvam, Director of Teqtis,...
Abhishek Malik, Executive Director, Calcom Vision Ltd

“India’s Electronics Sector Is Growing Rapidly, Making This The Decade For Investors To Engage”...

0
From the complexities of manufacturing and sourcing components to testing processes that drive innovation, know all the exciting dynamics shaping this ever-evolving industry in...
Sunit Kapur, CEO of Epsilon

“Epsilon Leads With Low-Carbon Graphite Manufacturing, Outpaces Chinese Competitors” – Sunit Kapur, CEO of...

0
Are LFP cathodes and silicon-graphite anodes the best for cost efficiency in EV batteries? Sunit Kapur, CEO of Epsilon Advanced Materials, discusses this with...
John W. Mitchell, President and CEO, IPC

“India’s Core Focus On 5G, IoT, AI Fosters Need For Advanced Electronics,Components, And Semiconductors”...

0
Will Industry 4.0 supercharge India’s progress in semiconductor and electronics manufacturing? IPC President and CEO John W. Mitchell shared more strategies on the country’s...

HKTDC Electronics Fair Sparks Innovation, 60,000+ Participants!

0
Showcasing cutting-edge tech, global innovation, and booming markets for the future of electronics, HKTDC’s Hong Kong Electronics Fair and electronicAsia drew 60,000+ professionals. Last month,...
Applied Materials Representational Image

Applied Materials Selects Six Startups For Deep-Tech Accelerator Programme

0
The selected deep-tech startups will be evaluated for investment by Applied Ventures and potential collaboration opportunities with Applied Materials. In collaboration with the company's India...

Space tech Startup Akash Secures $68M CHIPS Funding

0
Eyeing to power into AI, EVs, and more high-tech industries, Akash Systems lands $68 million CHIPS grant to boost its cooling tech facility, generating...

Wireless Light-Based Communication With Velmenni’s Technology

0
Velmenni is at the forefront of wireless communication innovation with its pioneering light-based technologies, Li-Fi and LC Link. Founded by Deepak Solanki in October 2014...

Harnessing AI Technology For Efficient Pest Management

0
AI-Genix, an agri-tech startup, is transforming pest management for farmers through advanced AI-enabled systems that precisely target harmful pests. In an industry where pesticides and...

Industry's Buzz

Learn From Leaders

Startups